These sturdy weld-in engine mounts allow the installer to fine-tune the engine placement according to transmission placement or other needs. A double rubber cushion on each side provides vibration isolation at the ends of the two mounts. The rubber cushions are secured with a large 5/8” diameter bolt. The engine side mounts have slots in them so you can position the engine closer to one side of the frame.
frame widths 23.35" to 29.35"
The engine mount kit includes two engine side mounts, two weld-in gusseted frame mounts, and rubber mount kit.
Note: These engine mounts fit the new Gen III / IV , LS-Series V8. The mounts have been designed to use with Truck exhaust manifolds or rear dump headers and will interfere with car (Corvette / Camaro / Trans-Am) exhaust manifolds.
Note: These engine / motor mounts are commonly used with Jeep YJ Wrangler and Jeep CJ Models
1997 to current GM 4L60E / 4L65E 4 speed automatic transmission to the Jeep NP231 transfer case with 23 spline input shaft, adapter kit.
After inspecting the components I was absolutely pleased with the quality of all of the parts in the kit. I have used other adapters in the past and belive that this kit is an exceptional value! Thanks and I will purchasing from you again in the future.